Skip to content

Connecting ONLINE units

AgnosPCB ONLINE AOI machines are powered by the INTEL NUC microcomputer and integrate all the software needed to control the camera and manage the AgnosPCB inspection tool software.

The CPU must be connected as indicated below:

  1. Connect the 2m USB cable (the straight cable) from the CAMERA micro-usb port to any USB 3.0 port (BLUE ports) of the INTEL NUC (diagram below)

  2. Insert the battery DUMMY into the Sony’s camera battery slot, and connect it to the provided 5V/3A USB power supply (as a separate unit or in the power strip).

    Camera with battery dummy

  3. Plug both LED panels into AC sockets. Both LED panels can be adjusted and turned ON/OFF using a single remote control (provided).

  4. Connect the ACTION button to an USB port of the INTEL NUC (any available).

    Platform connections

  5. Connect the monitor to the NUC´s HDMI port and the keyboard and mouse to the USB fronts port as below.

    Nuc front and back with its connections

The SONY camera uses a battery DUMMY, so it can be ON for unlimited time. That battery dummy needs a 5V and 3A power supply (provided with the KIT as a separate unit or integrated in the power strip). At the same time, the camera will be controlled from the computer, so use the provided high-speed 2m USB-micro USB cable to connect the camera to your INTEL NUC.

To install and configure the camera go to following section: How to connect the camera